Seville water with Thermomix

Preparing a cocktail with Thermomix is a very simple task because in most cases you just have to mix all the ingredients in different steps to end up having a delicious drink, like this water in Seville that recipesgratis shares today with you. If you want to know how to do A water from Seville with Thermomix you just have to take note of the ingredients and the steps to follow and you will get a refreshing and tasty drink to take whenever you want.

🚻 4 Diners🕘 10m🍵 Low Disturbance🤯
Ingredients to make water from Seville with Thermomix:
1 bottle of cava
1 liter of half -frosty pineapple juice
1 cup of cointreau
1 cup of whiskey
1 cup of rum
1 egg
sugar (optional)
ice
conela ground (optional)
nata mounted (optional)
ADDITIONAL CHARACTERISTICS: Cheap cost, Thermomix

Ingredients to make water from Seville with Thermomix:

1. To prepare this water recipe from Seville with Thermomix, the first thing we have to do is mount the snow-to-point egg. To do this, separate the light from the yolk, place it in the thermomix glass, put the butterfly and program it about 5 minutes at speed 4. Reserve it for later

2. Next, add to the thermomix glass the pìña juice, Cintreau, whiskey and rum and mix about 20 seconds at speed 5.

3. Then add the cava bottle gradually beating in progressive speed 5 to 9.



Trick: Add the sugar in this step if you want the sweetest Seville.

4. Finally, place the water from Seville in an adequate glass or jar, put some ice if it is not too cold, place the white to snow above and add some ground cinnamon or mounted cream if it is that it is that it is that It is desired. And Sevilles water will be ready with Thermomix! And if you like cocktail recipes with Thermomix, check out the following that we recommend below:- Valencia water with Thermomix

– Daiquiri with Thermomix

Recommended recipes